Match shredding disc orientation to the desired shred (e.g., 'fine shredding' side up)
When installing a reversible shredding disc, orient it so the labeled side for your target result (like 'fine shredding') faces up.
They note the disc labeling (fine shredding) and state they believe you put that side up to get the intended shred size before installing it.
The short version
- Disc orientation determines shred size
- Use the printed label to choose the correct side
What you need
- food processorWith reversible shredding disc
How to do it
- 1
Find the shred-size label on the disc (e.g., 'fine shredding').
Use the label as your orientation guide.
Watch this step - 2
Install the disc with the desired label facing up.
Double-check it’s seated before locking the lid.
Watch this step
What goes wrong
Installing the shredding disc upside down and getting the wrong shred size
Flip the disc so the desired shred label faces up
Why it works
Reversible discs cut differently depending on which side faces the food path.
Learn next
Use the oven as an alternative to an air fryer for finishing the pizza
If you don’t have an air fryer, you can finish cooking the topped pizza in the oven instead.
Finish a topped pizza in an air fryer at 180°C for 7 minutes
After topping the base, cook it in an air fryer at 180°C for about 7 minutes to melt cheese and heat through.
Expect a small end piece to remain in the feed tube when shredding/slicing
When shredding or slicing in a food processor, the last small piece often doesn’t feed through cleanly and may stick near the top.
Use the small feed-tube drip hole for slow, controlled liquid addition
If your food processor pusher has a small hole, use it to add liquids slowly (e.g., for dressings) while processing.